SKF Bearing Heater TIH030M/110V

Bea********* 0V version (RS 4979584) and 110V version (RS 6808018) SKF induction coil Bearing Heaters designed to carefully and evenly heat bearings that are mounted with an interference fit onto a shaft. Bearing heaters allow bearings to be installed without the need for specific hand tools. They eliminate the need for force to be applied to the bearing during installation. Bearing heaters can be used to heat other engineering components, such as gears, pulleys, bushes, where the bearing heater-component being heated forms a closed electrical circuit. The induction coil is housed outside the heater housing, providing a shorter heating time and reduced energy consumption during use. Foldable bearing support arms facilitate the heating of larger bearings/other suitable components, and a magnetic temperature probe helps prevent overheating. The heaters feature an integrated, easy-to-use control panel and handset/remote control. An integrated carrying handle is built into the bearing heater design, and each heater comes complete with three yokes. Features and Benefits • 2-step power setting and smaller yokes allow heating smaller bearings safely and at lower power consumption • Temperature mode pre-set at 110°C to prevent over-heating • Automatic demagnetisation • Capable of heating a 28kg bearing in 20 min • Compact lightweight design facilitating portability The TIH 100m has the same capabilities as the smaller heater but with increased capacity. The advanced design of the power electronics allows accurate electric current control. Technical Specification Voltage 230V, 50-60Hz Workpiece Max. Weight 40kg (88lb) Bore Range 20-300mm (0.8-11.8in.) Dimensions 450 x 195 x 210mm Total Weight (inc. yokes) 20.9kg (46lb) Max. Power Consumption 2.0kVA Standard Yokes Supplied 45 x 45 x 215mm 28 x 28 x 215mm 14 x 14 x 215mm Note No fitted electrical cable plug is supplied with the bearing heater. An approved electrical plug should be attached by a suitably-qualified individual to suit local requirements, such as: (UK) BS1363 rubber plug 488-387 ; (DE) Schuko rubber plug 849-6128 or 327-169 ; (FR) rubber plug 700-1094 ; or (US and JP) nylon plug 316-0133 TIH 030M 110 V The TIH 030m combines portability with high heating capacity. Capable of heating a 28kg bearing in 20 min Compact lightweight design facilitating portability SKF Electric Induction Heaters and Hot Plates enable bearings and other machinery components to be heated prior to installation. The induction heaters and hot plates are suitable for use with a variety of component sizes (actual sizes accepted depend on which induction heater or hot plate is used) and individual components may be heated to 200/250°C. SKF induction heaters and hot plates are thermostati********* ns, overheat protection is also incorporated into the units to ensure that the induction heater or hot plate is switched off in the event of thermostat failure.

SKF Bearing Heater TIH030M/110V

Location: Sydney 25 Pavesi Street Smithfield NSW 2164

N/A

When you call, Don't forget to mention ADSCT whenever you will call to user. Be safe during payment.